Incra V27 Miter Gauge

Incra V27 Miter Gauge

The Incra Miter V27 is the lowest cost miter gauge from Incra. It is a very basic miter gauge but built with a trademark Incra indexing protractor head. The head has 27 Vee notches (hence the V27 name) that are engaged by an indexing tooth for the most commonly used angle settings in 5 degree increments from +60 to -60 degrees. There are two notches for the +/- 22 1/2 degree setting provided also. The protractor head can also be locked down in any between angle settings but the index tooth is not controlling the angle when used in this manner. No cross fence is included with the V27.

The GlideLOCK bar is sized to fit most 3/4" wide x 3/8" deep slots on machinery, even when OEM's have sized them a little off. The Incra bar actually measures about 0.74" wide, the washers are adjusted to take up the extra slack in the slot. The GlideLOCK bar is also equipped with an optional T-slot adapter attached to the end. This is especially useful on tablesaws and is quickly removed if the miter gauge needs to be used on a non-T-slot machine.